i newly ordered the named evaluation Board. I tried to setup the Blink example following the documentation, but uploading anything didnt work.
The Link Utility was able to connect and set the connection type to "riscv ch32v30x wch-linkrv".
I then tried to use the get information from the chip but the utility states:
Failed,the chip type is not matched or status of chip is wrong!
When trying to get something on the chip with arduino ide (libary installed of course): Info : only one transport option; autoselect 'sdi' Warn : Transport "sdi" was already selected Ready for Remote Connections Info : WCH-Link-CH549 mode:RV version 2.10 Error: WCH-Link failed to connect with riscvchip Error: 1.Make sure the two-line debug interface has been opened. If not, set board to boot mode then use ISP tool to open it Error: 2.Please check your physical link connection Error: if your chip is CH32V00X,WCH-Link-CH549 does not support this chip, please use WCH-LinkE
Since im starting to do something like that, all of that is confusing, because in the wch documentation and on youtube, a wch link is used and it looks so easy. But my eval board has an usb c port intead of a link port. Is there anyone that can help? Do i need to change something on the board?(btw: power led red, run led green, con led off)